- ...
- Home
- Vibroacoustic Sealants
- MAXFORTE SEALANT
MAXFORTE SEALANT
- 9999992095.00
- Active material:Silicone
- Package size and weight:Tube: 23 x 5 x 5 cm, weight 500 g; in a box of 25 tubes
MaxForte vibroacoustic sealant is intended for sealing seals, joints and holes in soundproofing of walls and ceilings as well as in the structures of "floating" and joisted floors. Due to the low modulus of elasticity, the sealant shows the excellent vibroacoustic properties and acts as a damping layer significantly reducing the vibration load between the building structures.
Properties and advantages
MaxForte sealant is produced of high-quality imported raw materials (made in Belgium) which provide the excellent performance characteristics of this sealant and make it easy-to-squeeze, highly elastic and adhesive to all kinds of surfaces.
- Provides sound and vibration isolation.
- Reliable sealing regardless of seam thickness.
- High waterproofing properties.
- Non-aggressive media.
- Resistance to humidity changes, temperature fluctuations and solar radiation.
- High adhesion to all types of surfaces.
- Remains elastic after polymerization.
- Contains fungus inhibitors and mold inhibitors.
- White color. Odorless.
- Volume 310 ml
Interaction with materials
Recommended for use in structures made of the following materials: concrete, wood, bricks, plaster, plasterboard, gypsum plasterboard, glass magnesium board, OSB, wood chip board, plywood, glass, enamel, metals, ceramics, plastics.
Way of use
- Clean the sealed surfaces from dirt, dust and grease.
- Cut off the cartridge screw head above the thread. Screw on the nozzle and cut off the tip at an angle of 45º to obtain the required cross section.
- Fill the seam with a sealant using a sealant gun.
- Remove excess sealant and form a seam surface within 10 minutes.
Precautions
Carry out the works in the ventilated rooms. Avoid the contact of sealant with skin and eyes. If skin contact occurs, wash with plenty of warm water. The fully cured sealant is odorless and safe to handle.
Related Products
ECOSlab - Soundproof slab
The MaxForte-ECOslab sound-absorbing material is made of 100% volcanic rock (free of impurities, slag or blast-furnace wastes) in the form of slabs. These slabs feature the excellent acoustic properties and due to this can be successfully used for sound insulation of the premises which are the most difficult for soundproofing, such as: the multiplex cinemas, the recording studios, the listening rooms, the home theaters, etc.
SoundPRO - Soundproof roll
MaxForte-SoundPRO is a new generation material created on the basis of our know-how in the field of acoustical engineering and our expertise in mounting works. That’s why MaxForte-SoundPRO not only absorbs sound effectively but is also easy to mount. This material features a minimum thickness of 12 mm and provides the maximum protection against the airborne and impact noises. MaxForte-SoundPRO is indispensable in small apartments where every centimeter counts! This material is absolutely environmentally friendly: it is free of adhesives and other chemicals. MaxForte-SoundPRO is ideal for all kinds of premises including the apartments, the kindergartens and the schools. This material also serves as a fireproof insulation (since it is absolutely non-flammable) and a heat insulation!
Maxforte - Shumoizol
MAXFORTE ShumoIzol is designed for the effective protection against the vibrations and the impact and the structure-borne noises (repairs, footsteps of neighbors upstairs, creaking parquet, jumping children, etc.). The impact noise reduction index: ∆Lnw = 27 dB, allows to meet the standards with respect to the level of the impact noise in the buildings of all comfort categories (including class A “Luxury housing”).
This material combines the excellent soundproofing properties with the increased flexibility and the elasticity. A distinctive feature of MAXFORTE ShumoIzol is the added plasticizers preventing the material from melting at the temperatures of up to + 85ºC and cracking at the temperatures of down to -30ºC. MAXFORTE ShumoIzol may also serve as waterproofing since it is waterproof!
VibroStop PRO - Soundproof mount
VibroStop PRO is the anti-vibration fastener designed to combat the impact noise penetrating through the ceiling. Using VibroStop PRO allows to reduce significantly the vibration load applied to the profile and provides additional 21 dB soundproofing of the ceilings and walls!
ECOAcoustic Slab - Soundproof slab
MaxForte-EcoAcoustic sound-absorbing slabs are made from 100% polyester (polyester fibers) without the addition of adhesives. An innovative technology of thermal bonding (polyester fibers melting) is used for shaping. The material is made on modern equipment by SIMA (Italy) exclusively from primary raw materials. EcoAcoustic is absolutely safe for human health: the slabs are free of the harmful substances and do not emit them!
To ensure the maximum absorption of sound waves, the technology of aerodynamic layout of fibers is used with the formation of the layerless structure cloth (non-oriented arrangement of the fibers). The slabs are easy to mount since they are not inclined to splitting, crumbling or dusting. That’s why no overalls, gloves or respirator are required for working with this material.
MAХFORTE-ECOPANEL
MaxForte-ECOpanel is a durable soundproof panel made of a multi-layer frame filled with selected mineral quartz filler - the sand. The special design of the panel provides the multiple reflection and the dispersion of sound waves. Moreover, the non-bonded sand particles provide the high frictional losses. This additionally increases the dissipation, i.e. the transition of the acoustic energy of the sound wave into the heat energy due to the friction of the filler particles.
ECOSlab Floor - Soundproof slab
The MaxForte-ECOslab Floor. This material is intended for use as a component of "floating" screed structure in the floor soundproofing as well as for laying over the walls under the plaster. Sound-absorbing material is made of 100% volcanic rock (free of impurities, slag or blast-furnace wastes) in the form of slabs. These slabs feature the excellent acoustic properties and due to this can be successfully used for sound insulation of the premises which are the most difficult for soundproofing, such as: the multiplex cinemas, the recording studios, the listening rooms, the home theaters, etc.
ECOSlab Pro - Soundproof slab
The MaxForte-ECOslab Pro sound-absorbing material is made of 100% volcanic rock (free of impurities, slag or blast-furnace wastes) in the form of slabs. These slabs feature the excellent acoustic properties and due to this can be successfully used for sound insulation of the premises which are the most difficult for soundproofing, such as: the multiplex cinemas, the recording studios, the listening rooms, the home theaters, etc.
Vibrostop Standart - Soundproof mount
VibroStop Standart is the basic mount used for sound insulation of the KNAUF profile when soundproofing the ceilings and the walls. It provides reliable soundproofing against the domestic noise. This vibration insulating hanger is great for sound insulation of apartments due to its small thickness and suitability for use in thin soundproofing structures. VibroStop Standart mounted cladding improves sound insulation for up to 14 dB with thickness of only 4 cm!
Vibrostop Slim - Soundproof mount
VibroStop Slim is the anti-vibration fastener designed to combat the impact noise penetrating through the floor slabs and walls. Using VibroStop Slim allows to reduce significantly the vibration load applied to the profile and provides additional 21 dB soundproofing of the ceilings and walls!
DAMPING TAPE 50mm width
The self-adhesive tape of chemically cross-linked polyethylene foam is designed to soundproof the structure-borne noise as well as to seal and compensate the irregularities of floors, walls and ceilings at the abutments of the drywall structures frame guides.
MAXFORTE MEMBRANE SM
The MaxForte membrane SM (Self Adhesive) is an innovative state-of-the-art ultra-thin material (which is only 3.7 millimeters in thickness). The MaxForte viscoelastic membrane is a high-density synthetic polymer-based material free of bitumen or raw rubber. Thanks to such a composition, the membranes are elastic, resilient, strong and durable.
ECOSlab Slim - Soundproof slab
The MaxForte-ECOslab Slim sound-absorbing material is made of 100% volcanic rock (free of impurities, slag or blast-furnace wastes) in the form of slabs. These slabs feature the excellent acoustic properties and due to this can be successfully used for sound insulation of the premises which are the most difficult for soundproofing, such as: the multiplex cinemas, the recording studios, the listening rooms, the home theaters, etc.
MAXFORTE-LIGHT
MaxForte-Light is a damping backerboard for sound insulation of the floor (to be applied under a laminate, parquet or linoleum). The material consists of 100% polyester fiber and is free of harmful binders, therefore it is absolutely environmentally friendly. The special fibrous structure of MaxForte-Light significantly reduces the impact noise. Moreover, it is highly stable (it will not sag over time and no effect of booming sound or springing will occur). High sound insulation properties allow to reduce the impact noise down to 20 dB!
MAXFORTE HYDROINSULATION
Uni-component liquid rubber is designed to seal the seams of roll materials MaxForte-Standard and MaxForte-ShumoIzol. This compound is made from high-quality raw materials. It is a pasteous mass consisting of highly viscous latex emulsion, rubber and polymer additives.
Soundproof electric socket - 1 socket
Soundproof electric socket SoundBOX is used for installing electric sockets(outlets), electric switcher into soundproofing schemes. Minimal thickness allows you to install soundproof electric socket even in the thinnest soundproofing schemes.
Soundproof electric socket is made of high strength polymer, that provides long service life and high values of soundproofing.
Soundproof electric socket - 2 sockets
Soundproof electric socket SoundBOX is used for installing electric sockets(outlets), electric switcher into soundproofing schemes. Minimal thickness allows you to install soundproof electric socket even in the thinnest soundproofing schemes.
Soundproof electric socket is made of high strength polymer, that provides long service life and high values of soundproofing.
Soundproof electric socket - 3 sockets
Soundproof electric socket SoundBOX is used for installing electric sockets(outlets), electric switcher into soundproofing schemes. Minimal thickness allows you to install soundproof electric socket even in the thinnest soundproofing schemes.
Soundproof electric socket is made of high strength polymer, that provides long service life and high values of soundproofing.
Soundproof electric socket - 4 sockets
Soundproof electric socket SoundBOX is used for installing electric sockets(outlets), electric switcher into soundproofing schemes. Minimal thickness allows you to install soundproof electric socket even in the thinnest soundproofing schemes.
Soundproof electric socket is made of high strength polymer, that provides long service life and high values of soundproofing.
Soundproof electric socket - 5 sockets
Soundproof electric socket SoundBOX is used for installing electric sockets(outlets), electric switcher into soundproofing schemes. Minimal thickness allows you to install soundproof electric socket even in the thinnest soundproofing schemes.
Soundproof electric socket is made of high strength polymer, that provides long service life and high values of soundproofing.
DAMPING TAPE 100mm width
The self-adhesive tape of chemically cross-linked polyethylene foam is designed to soundproof the structure-borne noise as well as to seal and compensate the irregularities of floors, walls and ceilings at the abutments of the drywall structures frame guides.
DAMPING TAPE 150mm width
The self-adhesive tape of chemically cross-linked polyethylene foam is designed to soundproof the structure-borne noise as well as to seal and compensate the irregularities of floors, walls and ceilings at the abutments of the drywall structures frame guides.
VibroStop M6 - Soundproof mount
VibroStop M6 is a professional mount for vibration isolation of suspended engineering equipment, pipelines and other communications, as well as vibration isolation of the profile when soundproofing the ceiling, where a significant lowering of the ceiling is required.
ECOAcoustic Slab - Soundproof slab
MaxForte-EcoAcoustic sound-absorbing slabs are made from 100% polyester (polyester fibers) without the addition of adhesives. An innovative technology of thermal bonding (polyester fibers melting) is used for shaping. The material is made on modern equipment by SIMA (Italy) exclusively from primary raw materials. EcoAcoustic is absolutely safe for human health: the slabs are free of the harmful substances and do not emit them!
To ensure the maximum absorption of sound waves, the technology of aerodynamic layout of fibers is used with the formation of the layerless structure cloth (non-oriented arrangement of the fibers). The slabs are easy to mount since they are not inclined to splitting, crumbling or dusting. That’s why no overalls, gloves or respirator are required for working with this material.